Wednesday, November 18, 2026 Daily BriefMedia WatchFMCSA Newsroom ↗
FreightFiles.com: News, Policy, Courts, Guidance, Rulemaking, Enforcement

TxDOT Pilot Opens SH 130, SH 45 SE to OS/OW Trucks

So whatCarriers & drivers hauling oversize/overweight loads near Austin: request SH 130/SH 45 SE access through TxPROS notes when applying for a single-trip permit, and budget for tolls.

TxDOT started a pilot program on November 12 that lets eligible oversize and overweight permitted vehicles travel on SH 130 and SH 45 SE, two Austin-area toll roads. Eligible loads cannot exceed 16 feet in width, 16 feet in height, or 254,300 pounds gross weight (200,000 pounds if axle spacing is under 95 feet).

Motor carriers seeking a single-trip routed permit must request SH 130 or SH 45 SE access through the Notes feature in the Texas Permitting & Routing Optimization System. The Texas Department of Motor Vehicles' Motor Carrier Division reviews each request and routes approved vehicles onto the corridor. Carriers holding time-based permits may also use the two roads under the pilot. Travel on any other toll road still requires separate written permission from that toll authority. Carriers remain responsible for all toll charges, and access to the pilot corridor is limited to designated entrance and exit points.

This pilot is separate from the statewide size-and-weight suspension Governor Greg Abbott declared September 28, 2026, for fuel, agricultural, or timber loads under 95,000 pounds, which remains in effect under its own terms.

What's next

  • Program is live now; no stated end date or review period was given.
  • Carriers should check the TxDOT pilot program page for the corridor access map before routing loads.

All sources

TxDOT Pilot Opens SH 130, SH 45 SE to OS/OW Trucks
Illustration generated for FreightFiles.